Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not lubricate the O-ring seal prior to installation to the brake modulator assembly motor.

Fig 1: View Of EBC Position Sensor O-ring Seal

GM2037955

Courtesy of GENERAL MOTORS CORP.

Install a new O-ring seal to the brake modulator assembly motor. Ensure the seal is fully seated in the groove of the brake modulator assembly motor and is not twisted.

Fig 2: View Of EBC Position Sensor

GM2037954

Courtesy of GENERAL MOTORS CORP.

Install the electronic brake control position sensor (1).

NOTE: Refer to Fastener Notice .

Fig 3: View Of EBC Position Sensor Bolts

GM2037953

Courtesy of GENERAL MOTORS CORP.

Install the electronic brake control position sensor bolts (1). Tighten the bolts in a cross pattern.
Tighten: Tighten the bolts to 2 N.m (18 lb in).
Connect the electronic brake control position sensor electrical connector.

Fig 4: View Of ABS Module Splash Shield

GM1965627

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield (1).

Fig 5: View Of ABS Module Splash Shield Bolts

GM1965625

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield bolts (1).
Tighten: Tighten the bolts to 20 N.m (15 lb ft).

Fig 6: View Of ABS Module Splash Shield Retainers

GM1965624

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield retainers (1).
Install a scan tool to the vehicle.
Using the special functions menu on the scan tool, perform the electronic brake control sensor learn procedure.
Perform the Diagnostic System Check - Vehicle (without HP2) or Diagnostic System Check - Vehicle (with HP2) .