Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and 15.0 V.
- If not within the specified range, refer to Charging System Test .
- Ignition OFF, disconnect the harness connectors at the appropriate module.
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 30 seconds. Test for less than 5 Ω between the appropriate ground circuits listed below and ground.
- Terminal 13 (IPC)
- Terminal D (PPS)
- Terminal 8 X1 (Radio)
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Verify that a test lamp illuminates between the appropriate B+ circuit terminals listed below and ground.
- Terminal 2 (IPC)
- Terminal A (PPS)
- Terminal 1 X1 (Radio)
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the appropriate module.