Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the sunroof window. Refer to Sunroof Window Replacement (Extended Cab) or Sunroof Window Replacement (Crew Cab) .
Tighten: Tighten the screws to 4 N.m (35 lb in).
- Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement (Extended Cab) or Sunroof Motor/Actuator Replacement (Crew Cab) .
Tighten: Tighten the motor attachment screws to 3.5 N.m (31 lb in).
- Connect the electrical connector to the motor/actuator.
- Remove the pin (1) from the holes that held the position while installing the drive motor.
- Install the headliner. Refer to Headlining Trim Panel Replacement (Crew Cab) or Headlining Trim Panel Replacement (Extended Cab) or Headlining Trim Panel Replacement (Regular Cab) .
- Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab Existing Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab New Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab Existing Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab New Motor) .
- Verify the operation of the sunroof.
CAUTION:
Refer to Fastener Caution
.