FixVault
Home › Cadillac › 2012 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1548 (Lighting System) › Repair Instructions › Stop Lamp Switch Replacement (With Adjustable Pedals) › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  1. Install the stoplamp switch (1) to the power vacuum brake booster pushrod.
  2. Install the power vacuum brake booster pushrod with the stoplamp switch to the brake pedal pin.
    3. Fig 2: Locating Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  3. Install the power vacuum brake booster pushrod retainer (1).
  4. Rotate the pushrod retainer 360 degrees to verify the retainer is fully engaged in the groove on the brake pedal pin.
    5. Fig 3: Locating Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the power vacuum brake booster pushrod retainer bolt (1) and tighten to 10 N.m (89 lb in).
  6. Connect the stoplamp switch electrical connector.
  7. Install the driver knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .
About FixVault