FixVault
Home › Cadillac › 2012 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 384 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 6 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
  2. Connect the side impact sensor yellow 2-way connector (5) located near the bottom right of the door (4).
    Fig 1: View Of Connector Position Assurance (CPA) & Side Impact Sensor Yellow 2-Way Connector
    GM612189Courtesy of GENERAL MOTORS CORP.
  3. Install the CPA (3) to the side impact sensor yellow 2-way connector (5).
  4. Install the RF door trim panel. Refer toTrim Panel Replacement - Side Front Door (With YE9 Early Production)Trim Panel Replacement - Side Front Door (With YE9 Late Production) in Doors.
  5. Install the SIR fuse to the fuse block.
  6. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG indicator will then turn OFF.
  7. Perform the Diagnostic System Check - SIR  if the AIR BAG indicator does not operate as described.
About FixVault