FixVault
Home › Cadillac › 2012 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 785 (Battery, Charging System And Starting System) › Repair Instructions › Battery Positive Cable Replacement › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Under Hood Junction Block Cover
    GM1702793Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the under hood junction block cover.
    3. Fig 2: View Of Junction Block & Retainers
    GM1702795Courtesy of GENERAL MOTORS CORP.
  3. Lift the junction block retainers from the locked position (3) and rotate the retainers to the open position (1).
  4. Remove the junction block.
    5. Fig 3: View Of Positive Battery Cable Connector & (UBEC)
    GM1702797Courtesy of GENERAL MOTORS CORP.
  5. Remove the positive battery cable connector (1) from the underhood bussed electrical center (UBEC).
    6. Fig 4: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  6. Remove the mega fuse cover.
    7. Fig 5: View Of Generator Battery Jumper Cable & Components
    GM1699546Courtesy of GENERAL MOTORS CORP.
  7. Remove the generator battery jumper cable to mega fuse nut (3).
  8. Remove the generator battery jumper cable terminal (4) from the mega fuse stud.
    9. Fig 6: View Of Positive Battery Cable Channel, Clips & Studs
    GM1702801Courtesy of GENERAL MOTORS CORP.
  9. Remove the positive battery cable channel from the studs on the plenum front panel.
  10. Remove the positive battery cable clips from the studs on the plenum front panel.
    11. Fig 7: View Of Positive Battery Cable
    GM1702803Courtesy of GENERAL MOTORS CORP.
  11. Remove the positive battery cable terminal from the mega fuse stud.
  12. Remove the positive battery cable channel from the studs.
  13. Remove the positive battery cable from the vehicle.
About FixVault