FixVault
Home › Cadillac › 2012 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 811 (HVAC System - Automatic) › Repair Instructions › Inside Air Temperature Sensor Assembly Replacement › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left windshield garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar .
  2. Remove the left center pillar assist handle. Refer to Roof Rail Rear Assist Handle Replacement .
  3. Remove the center pillar garnish molding. Refer to Garnish Molding Replacement - Center Pillar Upper .
  4. Remove the left sunshade. Refer to Sunshade Replacement .
  5. Gently pull down the headliner.
    6. Fig 1: View Of Inside Air Temperature Sensor Electrical Connector
    GM675996Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electrical connector from the inside air temperature sensor.
  7. Partially remove the inside air temperature sensor from the headliner.
  8. Remove the sensor grille from the inside air temperature sensor.
    9. Fig 2: View Of Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS CORP.
  9. Remove the inside air temperature sensor from the headliner.
About FixVault