Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Coil Spring & Upper Insulator

Courtesy of GENERAL MOTORS CORP.

Install the coil spring and the upper insulator.
Raise the rear axle.

NOTE: Refer to Fastener Notice .

Fig 2: View Of Shock Absorber Upper & Lower Nuts & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the lower shock absorber retaining nut and bolt to the rear axle.
Tighten: Tighten the lower shock absorber retaining nut and bolt to 95 N.m (70 lb ft).

Fig 3: View Of Stabilizer Shaft Link Nut & Ball Stud (15/25 Series)

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft link to the frame.
Install the stabilizer shaft link retaining nut.
Tighten: Tighten the stabilizer shaft link retaining nut to 75 N.m (55 lb ft).
Connect the ESC sensor, if equipped. Refer to Rear Position Sensor Link Assembly Replacement - Electronic Suspension .
Remove the rear axle support.
Lower the vehicle.