Installation Procedure
Courtesy of GENERAL MOTORS COMPANY
- Install the spark plug wires at the ignition coil.
- Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, complete the following procedure:
- Apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers
.
- Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.
- Install the spark plug wire to each spark plug.
- Inspect the wires for proper installation:
- Push sideways on each boot in order to inspect the seating.
- Reinstall any loose boot.