FixVault
Home › Cadillac › 2014 › ELR › Repair and Diagnosis › Suspension › Front Suspension › Front Suspension System › Repair Instructions › Lower Control Arm Replacement › Installation Procedure

Installation Procedure

    Fig 1: Front Lower Control Arm, Nuts And Bolts
    GM2381096Courtesy of GENERAL MOTORS COMPANY
  1. Position the front lower control arm (2) on the vehicle.
    2. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

    NOTE:
    • Start all front lower control arm fasteners by hand before tightening to specification to aid in installation.
    • Use a suitable support to bring the front lower control arm and front suspension to the proper trim height before tightening any fasteners.
  2. Install the NEW front lower control arm front bolt (5) and OLD nut (4) and tighten the bolt to 70 N.m (52 lb ft) + 75-90 degrees.
  3. Install the NEW steering knuckle bolt (1) and OLD nut (3) and tighten the nut to 115 N.m (85 lb ft) + 120-135 degrees.
    4. Fig 2: Front Lower Control Arm Nut And Bolt
    GM2381101Courtesy of GENERAL MOTORS COMPANY
  4. Install the NEW front lower control arm rear bolts (2) and OLD nuts (1) and tighten the bolts to 70 N.m (52 lb ft) + 75-90 degrees.
  5. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
About FixVault