Installation Procedure

Position the electronic parking brake control module (1) to the electronic parking brake control module bracket.

Fig 1: Electronic Parking Brake Control Module
Courtesy of GENERAL MOTORS COMPANY
Inspect the O-ring seals on the spindle and the intermediate cable for damage and correct positioning and replace, if necessary.
Install the parking brake intermediate cable nut (1) and tighten to 6 N.m (53 lb in).

Fig 2: Parking Brake Intermediate Cable Nut
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .

NOTE: When installing the electronic park brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.
Maneuver and install the electronic parking brake control module and bracket to the rear suspension support.
Connect the electronic parking brake control module electrical connector.
Install the electronic parking brake control module bracket bolts (1) and tighten to 9 N.m (80 lb in).

Fig 3: Electronic Parking Brake Control Module Bracket Bolts
Courtesy of GENERAL MOTORS COMPANY
Install the electronic parking brake control module bolts (1) and tighten to 7 N.m (62 lb in).

Fig 4: Electronic Parking Brake Control Module Bolts
Courtesy of GENERAL MOTORS COMPANY
Program the electronic parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup .