FixVault
Home › Cadillac › 2016 › CTS Base, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions › Repair Instructions › Fuel Tank Replacement › Installation Procedure

Installation Procedure

  1. Install the following components if fuel tank replacement was necessary:
    1. Fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
  2. Use a suitable jack and install the fuel tank (1).
    Fig 1: Fuel Tank
    GM2815733Courtesy of GENERAL MOTORS COMPANY
  3. Install the fuel tank straps (2).
    Fig 2: Fuel Tank Straps And Bolts
    GM2815736Courtesy of GENERAL MOTORS COMPANY
  4. Install the fuel tank strap bolts (1) and tighten to 20 N.m (15 lb ft).
    CAUTION: Refer to Fastener Caution .
  5. Connect the evaporative emission and fuel pipes (2). Refer to Plastic Collar Quick Connect Fitting Service .
    Fig 3: Evaporative Emission And Fuel Pipes
    GM2815749Courtesy of GENERAL MOTORS COMPANY
  6. Connect the fuel tank electrical connector.
  7. Install the two piece propeller shaft. Refer to Two-Piece Propeller Shaft Replacement (LT4, LTG) .
  8. Install the left rear suspension bracket. Refer to Rear Suspension Bracket Replacement (Rear)
  9. Install the left and right side rear air deflectors. Refer to Underbody Rear Air Deflector Replacement - Left Side and Underbody Rear Air Deflector Replacement - Right Side .
  10. Refill the fuel tank.
  11. Inspect for fuel leaks.
About FixVault