Throttle Body Cleaning
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .WARNING: Refer to Safety Glasses Warning .
- Fully open the throttle valve in order to Inspect the throttle body bore and the throttle valve plate for any deposits.
- Use a clean shop towel and an approved GM engine cleaner. Clean the throttle body bore and the throttle valve plate.CAUTION:
Do not subject a throttle body assembly which contains the following components to an immersion cleaner or a strong solvent:
- Throttle position (TP) sensor
- Idle air control (IAC) valve
- Sealed throttle shaft bearings
The cleaners will damage the electric components or sensors.
The cleaners will damage some of these components that contain seals or O-rings.
Solvents can wash away or break down the grease used on non-serviceable throttle shaft bearings.
Never use a wire brush or scraper to clean the throttle body. A wire brush or sharp tools may damage the throttle body components.
Do not use a cleaner that contains methyl ethyl ketone. This extremely strong solvent may damage components and is not necessary for this type of cleaning.
If necessary, use a parts cleaning brush in order to remove heavy deposits.
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
- Perform the throttle idle learn procedure. Refer to Throttle or Idle Learn .