FixVault
Home › Cadillac › 2016 › ELR › Repair and Diagnosis › General Information › Reset Procedures › Programming And Setup - All Systems › Repair Instructions › Steering Column Lock Module Programming and Setup › Replace and Program Steering Column Lock Control Module or Reprogram Steering Column Lock Control Module

Replace and Program Steering Column Lock Control Module or Reprogram Steering Column Lock Control Module

NOTE:

Before reprogramming, to ensure that the steering column lock password from the BCM is learned: turn ignition ON and then OFF, close all doors, and wait 5 minutes.

To program a replacement steering column lock control module or reprogram an existing steering column lock control module, perform the following procedure:

  1. Ignition ON for one minute, ignition OFF.
  2. Close all doors and wait 5 minutes.
  3. Install EL-49642  SPS programming support tool.
  4. Ignition ON.
  5. Access the Service Programming System (SPS) and follow the on-screen instructions.
  6. On the SPS Supported Controllers screen, select Steering Column Lock Control Module - Programming and follow the on-screen instructions.
  7. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
About FixVault