FixVault
Home › Cadillac › 2017 › CT6 Plug-In › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Antilock Brake System - Except Hybrid) › Repair Instructions › Brake Pressure Modulator Valve Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Brake Pressure Modulator Valve Assembly (1)» Install
    Fig 1: Brake Pressure Modulator Valve Assembly
    GM4245827Courtesy of GENERAL MOTORS COMPANY
  2. Brake Pressure Modulator Valve Bracket Bolt (1)» Install and tighten 9 N.m (80 lb in)
    Fig 2: Brake Pressure Modulator Valve Bracket Bolt
    GM4245826Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Fastener Caution
  3. Brake Pressure Modulator Valve Bracket Bolt (1)» Install and tighten 9 N.m (80 lb in)
    Fig 3: Brake Pressure Modulator Valve Bracket Bolt
    GM4245825Courtesy of GENERAL MOTORS COMPANY
  4. Brake Pressure Modulator Valve Bracket Nut (1)» Install and tighten 9 N.m (80 lb in)
    Fig 4: Brake Pressure Modulator Valve Bracket Nut
    GM4245824Courtesy of GENERAL MOTORS COMPANY
  5. Right Rear Brake Pipe Fitting (1)» Install and tighten 19 N.m (14 lb ft)
    Fig 5: Right Rear Brake Pipe Fitting
    GM4245823Courtesy of GENERAL MOTORS COMPANY
  6. Left Front Brake Pipe Fitting (1)» Install and tighten 19 N.m (14 lb ft)
    Fig 6: Left Front Brake Pipe Fitting
    GM4245821Courtesy of GENERAL MOTORS COMPANY
  7. Right Front Brake Pipe Fitting (1)» Install and tighten 19 N.m (14 lb ft)
    Fig 7: Right Front Brake Pipe Fitting
    GM4245820Courtesy of GENERAL MOTORS COMPANY
  8. Left Rear Brake Pipe Fitting (1)» Install and tighten 19 N.m (14 lb ft)
    Fig 8: Left Rear Brake Pipe Fitting
    GM4245819Courtesy of GENERAL MOTORS COMPANY
  9. Brake Pressure Modulator Valve Secondary Pipe Fitting (1)» Install and tighten 32 N.m (24 lb ft)
    Fig 9: Brake Pressure Modulator Valve Secondary Pipe Fitting
    GM4245818Courtesy of GENERAL MOTORS COMPANY
  10. Brake Pressure Modulator Valve Primary Pipe Fitting (1)» Install and tighten 32 N.m (24 lb ft)
    Fig 10: Brake Pressure Modulator Valve Primary Pipe Fitting
    GM4245817Courtesy of GENERAL MOTORS COMPANY
  11. Connect the EBCM electrical connector.
  12. Bleed the brake system. Refer to Antilock Brake System Automated Bleed 
  13. Engine Wiring Harness Fuse Block Bracket» Install - Engine Wiring Harness Fuse Block Bracket Replacement
  14. Program the EBCM. Refer to Control Module References
  15. Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering 
About FixVault