Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Front Link Bolt | |
|
100 N.m (74 lb ft) |
|
90-105 degrees |
| Front Lower Control Rear Link Bolt | |
|
100 N.m (74 lb ft) |
|
90-105 degrees |
| Wheel Stud | |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Stabilizer Shaft Insulator Clamp Nut | 22 N.m (16 lb ft) |
| Front Stabilizer Shaft Link Nut | 120 N.m (89 lb ft) |
| Front Suspension Strut Bumper Stop | 25 N.m (18 lb ft) |
| Front Suspension Strut Mount Nut (With F55 at Top of Front Suspension Strut Mount) | 48 N.m (35 lb ft) |
| Front Suspension Strut Mount Nut (Without F55 at Top of Front Suspension Strut Mount) | 60 N.m (44 lb ft) |
| Front Suspension Strut Nut (at Steering Knuckle) | |
|
150 N.m (111 lb ft) |
|
80-95 degrees |
| Front Suspension Strut Upper Mounting Nut | 22 N.m (16 lb ft) |
| Front Wheel Bearing and Hub Assembly Bolt (Non V-Series With AWD) | 130 N.m (96 lb ft) |
| Front Wheel Bearing and Hub Assembly Bolt (Non V-Series With RWD) | 118 N.m (87 lb ft) |
| Front Wheel Bearing and Hub Assembly Bolt (V-Series) | |
|
100 N.m (74 lb ft) |
|
15-30 degrees |
| Steering Knuckle Nut | |
|
40 N.m (30 lb ft) |
|
120-135 degrees |