Circuit/System Verification

Vehicle in Service Mode.
Verify that no other DTCs are set except for P2299.
- If any other DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no other DTCs are not set
Verify the brake pedal position sensor or the brake pedal is not binding causing residual brake pressure to be detected.
- If a condition is found
  Repair or replace the applicable component.
- Go to next step: If a condition is not found
Verify the scan tool electronic brake control module Brake Pedal Position Sensor Signal parameter changes between Applied and Released when applying and releasing the brake pedal.
- If the parameter does not change
  Refer to Symptoms - Lighting .
- Go to next step: If the parameter changes
Replace the K17 Electronic Brake Control Module.