Removal Procedure
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Engine Wiring Harness Fuse Block Bracket - Remove - Engine Wiring Harness Fuse Block Bracket Replacement
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
- Disconnect the EBCM electrical connector.
Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Secondary Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Low Pressure Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pipe Fitting (Left Front) (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pipe Fitting (Right Front) (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pipe Fitting (Left Rear) (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pipe Fitting (Right Rear) (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Bracket Nut (1) - Remove
Brake Pressure Modulator Valve Bracket Bolt (1) - Loosen
Brake Pressure Modulator Valve Bracket Bolt (1) - Loosen
Brake Pressure Modulator Valve Assembly (1) - Remove