Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Assembly (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Pressure Modulator Valve Bracket Bolt (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Bolt (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Nut (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Right Rear Brake Pipe Fitting (1) - Install and tighten 19 N.m (14 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Left Front Brake Pipe Fitting (1) - Install and tighten 19 N.m (14 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Right Front Brake Pipe Fitting (1) - Install and tighten 19 N.m (14 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Left Rear Brake Pipe Fitting (1) - Install and tighten 19 N.m (14 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Connect the EBCM electrical connector.
Bleed the brake system. Antilock Brake System Automated Bleed
Engine Wiring Harness Fuse Block Bracket - Install - Engine Wiring Harness Fuse Block Bracket Replacement
Program the EBCM. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering (without UKL) Steering Wheel Angle Sensor Centering (with UKL)