Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Position the intermediate steering shaft (1) on the vehicle.

Courtesy of GENERAL MOTORS COMPANY

Prepare the intermediate steering shaft upper bolt (1) for installation.

1. Prepare the bolt for installation as follows:
2. Remove all traces of the adhesive patch from the bolt and the mating threads using the appropriate tools.
3. Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
4. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers 
5. Ensure there are no gaps in the thread locking adhesive once applied to the bolt.

Courtesy of GENERAL MOTORS COMPANY

Prepare the intermediate steering shaft lower bolt (1) for installation.

1. Prepare the bolt for installation as follows:
2. Remove all traces of the adhesive patch from the bolt and the mating threads using the appropriate tools.
3. Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
4. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers 
5. Ensure there are no gaps in the thread locking adhesive once applied to the bolt.

Courtesy of GENERAL MOTORS COMPANY

Front Wheel Drive Shaft-Left Side (1) - Install - Front Wheel Drive Shaft Replacement - Left Side

Courtesy of GENERAL MOTORS COMPANY

Install the engine front splash rear shield (1). Engine Front Splash Rear Shield Replacement