Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Front Link Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Lower Control Rear Link Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Stabilizer Shaft Insulator Clamp Nut | 22 N.m (16 lb ft) |
| Front Stabilizer Shaft Link Nut- Lower | 130 N.m (96 lb ft) |
| Front Stabilizer Shaft Link Nut- Upper | 120 N.m (89 lb ft) |
| Front Suspension Strut Bumper Stop | 25 N.m (18 lb ft) |
| Front Suspension Strut Mount Nut - FE2, FE3, FE4 with F55 | 48 N.m (35 lb ft) |
| Front Suspension Strut Mount Nut - FE2 without F55 | 60 N.m (44 lb ft) |
| Front Suspension Strut Nut@Steering Knuckle | |
|
150 N.m (111 lb ft) |
|
80 - 95 degrees |
| Front Suspension Strut Upper Mounting Nut | 22 N.m (16 lb ft) |
| Front Wheel Bearing and Hub Assembly Bolt - Non V-Series With AWD | 130 N.m (96 lb ft) |
| Front Wheel Bearing and Hub Assembly Bolt - Non V-Series With RWD | 118 N.m (87 lb ft) |
| Front Wheel Bearing and Hub Assembly Bolt - V-Series | |
|
100 N.m (74 lb ft) |
|
15 - 30 degrees |
| Steering Knuckle Nut | |
|
40 N.m (30 lb ft) |
|
120 - 135 degrees |