Removal Procedure

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Place the ignition switch in the OFF position.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Clean the area surrounding the electronic brake control module (EBCM) and brake pressure modulator valve (BPMV) assembly of any accumulated dirt and debris.
Disconnect the EBCM electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the master cylinder secondary brake pipe fitting (1).
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Disconnect the master cylinder primary brake pipe fitting (2).
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the left rear brake pipe fitting (1).
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Disconnect the right rear brake pipe fitting (2).
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the right front brake pipe fitting (1).
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Disconnect the left front brake pipe fitting (2).
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
It is not necessary to remove the BPMV bracket bolts.

Loosen, but do not remove, the BPMV bracket bolts (1).
Slide the BPMV and bracket assembly toward the rear of the vehicle and remove the assembly.
If necessary, remove the BPMV bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
Remove the EBCM, if necessary. Refer to Electronic Brake Control Module Replacement .