FixVault

Installation Procedure

  1. If replacing the fuel tank transfer the following components.
  2. GM2673852Courtesy of GENERAL MOTORS COMPANY

    With the aid of an assistant, position the fuel tank on a hydraulic lift and raise into vehicle position.

  3. CAUTION:

    Refer to Fastener Caution .

  4. Install both fuel tank straps (2) to the fuel tank (1) and tighten the fasteners (3) to 27 N.m (20 lb ft).
  5. Remove the hydraulic lift from the fuel tank.
  6. GM3336887Courtesy of GENERAL MOTORS COMPANY

    Connect the evaporative emission purge and fuel pipes (1). Plastic Collar Quick Connect Fitting Service 

  7. Connect the fuel pressure sensor harness connector (2).
  8. Install the right rear underbody air deflector. Underbody Rear Air Deflector Replacement - Right Side (AWD)
  9. Install the right front underbody air deflector. Underbody Front Air Deflector Replacement - Right Side
  10. GM2203818Courtesy of GENERAL MOTORS COMPANY

    Install the fuel tank filler tube (2) and tighten the clamp (1) to 4 N.m (35 lb in).

  11. Connect the fuel tank filler vent pipe to the fuel tank filler vent pipe (3). Plastic Collar Quick Connect Fitting Service 
  12. GM3336926Courtesy of GENERAL MOTORS COMPANY

    Connect the fuel tank fuel pump module wiring harness (1).

  13. Install the exhaust system. Exhaust Muffler Replacement (FWD) , or Exhaust Muffler Replacement (AWD)
  14. Install the two front differential mounting bolts. Differential Carrier Assembly Replacement
  15. Install the propeller shaft. Propeller Shaft Replacement
  16. Refuel the fuel tank.
  17. Inspect for fuel leaks.