Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Steering Column Tilt Wheel and Telescope Control Module (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution .

Steering Column Tilt Wheel and Telescope Control Module Bolt (1) - Install and tighten [2x] 3 N.m (27 lb in)
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector. (1)
Courtesy of GENERAL MOTORS COMPANY

Steering Column (1) - Install - Steering Column Replacement
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct - Left Side (2) - Install - Floor Front Air Outlet Duct Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Steering Column Lower Trim Cover (1) - Install - Steering Column Lower Trim Cover Replacement (N38) , or Steering Column Lower Trim Cover Replacement (N37)
Instrument Panel Lower Trim Panel Insulator - Left Side - Install - Instrument Panel Lower Trim Panel Insulator Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
The anti-rotation pin must be removed from the steering column before installing the steering wheel. Ensure that the steering wheel bolt is torqued to specification during steering wheel installation. Over torquing the steering wheel bolt can result in damage to the steering column rivets which will disable the telescoping mechanism. If the steering column rivets are damaged, a new steering column must be installed.

Remove the CH-42640 Steering Column Anti-Rotation Pin (1) from the steering column lower access hole.
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel (1) - Install - Steering Wheel Replacement
Enable the SIR System. SIR Disabling and Enabling
Program the steering column tilt wheel and telescope control module. Control Module References