Fastener Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Power Steering Assist Motor Seal |
| Power Steering Control Module Wiring Harness Retainer |
| Power Steering Wiring Harness Extension Harness Retainer |
| Steering Gear Boot Inner Clamp |
| Steering Gear Shaft Dampener Ring |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Steering Assist Motor Bolt | 10 N.m (89 lb in) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Steering Wiring Harness Extension Harness Ground Bolt | 6 N.m (53 lb in) |
| Steering Gear Belt Access Plug | 12 - 14 N.m (106 - 124 lb in) |
| Steering Gear Bolt - Left Side | 220 N.m (162 lb ft) |
| Steering Gear Bolt - Right Side | 100 N.m (74 lb ft) |
| Steering Linkage Inner Tie Rod | 120 N.m (89 lb ft) |
| Steering Linkage Outer Tie Rod Nut | |
|
35 N.m (26 lb ft) |
|
85 - 100 degrees |