FixVault
Home › Cadillac › 2021 › CT4 V, RWD › Repair and Diagnosis (Single Page) › Accessories & Equipment › Collision/Avoidance › Driver Assistance Systems › Repair Instructions › Automated Driving Mapping Module Replacement › Installation Procedure

Installation Procedure

  1. GM5866933Courtesy of GENERAL MOTORS COMPANY

    Automated Driving Mapping Module (1) - Install

  2. Secure the retaining tab.
  3. Connect the electrical connectors.
  4. GM5470126Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Side Trim - Right Side (2) - Install

  5. Rear Compartment Side Trim Insulator Retainer (1) - Install [4x]
  6. GM5471885Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Panel Trim (2) - Install

  7. Rear Compartment Floor Stowage Compartment Retainer (1) - Install [3x]
  8. GM5465255Courtesy of GENERAL MOTORS COMPANY

    Rear End Trim Finish Panel (1) - Install

  9. GM5459293Courtesy of GENERAL MOTORS COMPANY

    Rear End Trim Finish Panel Opening Cover (1) - Install

  10. GM5471799Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Panel Trim (1) - Install

  11. GM5459270Courtesy of GENERAL MOTORS COMPANY

    Cargo Tie Down Loop (3) - Install [2x]

  12. Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
  13. Cargo Tie Down Loop Bolt Cap (1) - Install [2x]
  14. Perform the necessary programming and setup procedure: Control Module References
About FixVault