1975 Models
- On all models except Motor Home Chassis, remove air cleaner. Check that choke and rod move freely. Disconnect choke rod from choke lever and hold choke valve closed. With rod pushed down to bottom of travel, top of rod should be even with bottom hole in choke lever. To adjust, bend rod at offset point in rod.
- On Motor Home Chassis (455" engine), position fast idle cam follower on highest step of fast idle cam loosen screws on cover and rotate choke assembly until choke valve closes. Set choke cover at index mark.
NOTE:
Some 7976 pickup models with 350" or 400" 4-Bbl. engines may hesitate or stall on cold acceleration. This condition may be corrected by installing a new choke coil assembly (46110).