FixVault
Home › Chevrolet › 1976 › Chevette Base, Standard Trans › Repair and Diagnosis › Engine Mechanical › Auxiliary Emission Control Systems › Catalytic Converters › Service › Shell Replacement › General Motors Corp.

General Motors Corp.

  1. Remove bottom cover by making a shallow, close cut to bottom outside edge.
    NOTE: A shallow cut is required to avoid damage to inner shell.
    Fig 1: Removal of Converter Bottom Cover
    G09320118Courtesy of CHRYSLER GROUP, LLC
  2. Remove insulation and check inner shell for damage. If damage is found, entire converter must be replaced.
  3. If no damage is found, position new insulation into replacement cover. Apply sealer (8998245) around edge of cover, using extra sealer at front and rear pipe openings.
  4. Install replacement cover on converter and position retaining channel along edges. Complete the installation by attaching clamps (provided with replacement cover) to both ends of converter.
About FixVault