Low-Reverse Clutch: Reassembly

1. Install clutch apply ring on low and reverse hub clutch piston. Install new inner and outer seals on clutch piston (seal lips facing away from apply ring side). Lubricate clutch seal with transmission fluid.
2. Install Seal Protector (J-25011) into clutch housing hub. Using a flat tip screwdriver to start seal into housing, install clutch piston, rotating while pushing down into bore. Remove seal protector. Install waved spring, retainer (cupped side down) and snap ring.

Fig 1: Exploded View of Low-Reverse Clutch Assembly

Courtesy of GENERAL MOTORS CORP.