Low-Reverse Clutch

Lubricate with transmission fluid then install low-reverse clutch plates, starting with a flat steel plate, and alternating composition and flat steel plates until all clutch plates are installed. See LOW-REVERSE CLUTCH PLATE USAGE . Install waved steel clutch plate on top of last flat steel plate.
Install low-reverse clutch housing-to-case spacer ring into case. Install low-reverse clutch housing assembly, aligning housing oil feed hole with case oil feed passage.

If housing does not seat past snap ring groove, proceed as follows: Install input drum and rear sun gear assembly into case and rotate back and forth to align roller clutch race and low-reverse clutch hub splines. Remove input drum and sun gear.

LOW-REVERSE CLUTCH PLATE USAGE

Model Application

⁽¹⁾ Flat Steel

Composition

All Models

⁽²⁾ 7

⁽¹⁾	Plate thickness is 0.077" (1.96 mm).

⁽²⁾	Plus 1 WAVED steel plate 0.077" (1.96 mm) thick, installed last.

Repeat step 3) if low-reverse clutch housing still is not seated past case snap ring groove. With parts properly seated, install low-reverse clutch housing-to-case snap ring, with flat side of ring against housing (beveled side upward). Locate snap ring gap opposite parking pawl rod.

NOTE: It may be necessary to loosen adjusting screw on output shaft support tool to install low-reverse clutch housing-to-case snap ring.