FixVault
Home › Chevrolet › 1991 › Corvette Base, 2D Convertible, Standard › Repair and Diagnosis › Brakes › Traction Control › Anti-Lock Brake System › Bleeding Brake System › Pressure Bleeding Procedure

Pressure Bleeding Procedure

  1. Install Bleeder Adapters (J-29567 and J-34098) to brake master cylinder. Pressurize bleeder to 20-25 psi (1.4-1.8 kg/cm2 ). Connect bleeder hose to adapter and bleed air from adapter.
  2. Place proper size box end wrench over bleeder valve. Attach one end of clear tube over valve and submerge other end in container partially filled with clean brake fluid.
  3. Starting at right front wheel, loosen bleeder valve 3/4 turn to purge air from cylinder. Tighten bleeder valve when no more air exists. Remove tube and wrench. Tighten bleeder valve to 80 INCH lbs. (9 N.m).
  4. Repeat procedure on remaining brake calipers in following sequence: right rear wheel, left rear wheel and left front wheel. Remove pressure bleeder and adapters. Ensure master cylinder is full. Install master cylinder cover.
About FixVault