FixVault
Home › Chevrolet › 1996 › Beretta Base, 2.2 4, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - System/Component Tests - 2.2L › Engine Sensors & Switches › Engine Oil Level Switch

Engine Oil Level Switch

  1. Turn ignition on, with engine off. If "Low Oil Level" light turns on, go to next step. If "Low Oil Level" light does not turn on, connect test light between battery voltage and PCM connector terminal BC7 (Brown/White wire). If test light illuminates, check for blown fuse, open in Brown/White or Dark Green wire to PCM, or faulty indicator bulb. If test light does not illuminate, check Brown/White wire for short to battery voltage. See Figure . If circuit is okay, replace PCM.
  2. Check engine oil level. If oil level is okay, go to next step. If engine oil level is not okay, check level again using Tech 1 scan tool. If scan tool indicates LOW, fill crankcase and repeat step 1). If scan tool does not indicate LOW, disconnect engine oil level switch connector. If scan tool still indicates LOW, replace engine oil level switch. If scan tool does not indicate LOW, check Brown wire between PCM and engine oil level switch for short to ground. If circuit is okay, check for faulty PCM connection or faulty PCM.
  3. Start engine. If "Low Oil Level" light turns off, turn ignition off and go to step 5). If "Low Oil Level" light stays on, turn ignition off. Disconnect PCM harness connector. Turn ignition on. Using a test light connected to battery voltage, probe PCM connector Brown/White wire terminal. If test light illuminates, repair short to ground in Brown/White wire. If test light does not illuminate, go to next step.
  4. Backprobe PCM connector Brown wire terminal. If test light illuminates, replace PCM. If test light does not illuminate, check for open or shorted Brown wire between PCM and engine oil level switch, or open in Black wire from engine oil level switch. If circuits are okay, replace oil level switch.
  5. Turn ignition on, with engine off. Disconnect engine oil level switch harness connector. If scan tool now indicates oil level as LOW, system is okay. If scan tool does not indicate LOW, check for short to ground in Brown wire between PCM and oil level switch. If circuit is okay, replace PCM.
About FixVault