Lock Cylinder (Non-Functional): Removal

Remove steering Column. See STEERING COLUMN . Using Modular Column Holding Fixture (J-41352), secure steering column. Remove tilt lever, if equipped. Remove 2 lower shroud screws. Tilt lower shroud down and slide back to disengage locking tabs, then remove lower shroud. Remove upper shroud.
Remove retaining ring. Remove SIR clockspring assembly. See AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIP section. Remove wave washer. Using Lock Plate Compressor (J-23563-SIR), remove and discard retaining ring. Remove shaft lock shield assembly. Remove turn signal cancelling cam.
On models with park lock cable, ensure lock cylinder is in OFF-LOCK position and gearshift is in Park. Insert small screwdriver into slot in lock module assembly, push against locking tab on end of cable and remove park lock cable.
On all models, remove 3 screws, and remove lock module assembly with upper shroud. Remove backing plate from lock module assembly. Mark 2 sector gears at PARK-LOCK position for installation reference. See Figure. Remove both sector gears.
Using 1/8" burring tool, remove positioning tab on end of lock cylinder. See Figure. Remove all burrs in and around lock module assembly and lock cylinder. From inside lock module assembly, push on locking tab and pull out lock cylinder. Clean debris from lock module assembly.

NOTE: Ensure 2 sector gears are properly aligned at OFF-LOCK position, or lock cylinder will be improperly timed.