FixVault
Home › Chevrolet › 2000 › Astro Van Cargo, AWD › Repair and Diagnosis › External Pages › Different car › Section 794 (Anti-Lock Brake System) › Repair Instructions › Electronic Brake Control Module (EBCM) Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Important:  After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.

  1. Remove the fuel pipe shield (3) from the frame bracket (2) by removing the 2 nuts (4).

    Important:  Thoroughly wash all contaminants from around the EHCU (1). The area around the EHCU must be free from loose dirt to prevent contamination of disassembled ABS components.

  2. Disconnect the electrical connectors from the EBCM.
    Fig 1: Locating EBCM
    G02502467Courtesy of GENERAL MOTORS CORP.
  3. Remove the 4 T 25 Torx® mounting screws (1) that fasten the EBCM (2) to the BPMV (5).
  4. Remove the EBCM (2) from the BPMV (5). Removal may require a light amount of force.

    Important:  Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.

    5. Fig 2: Removing EBCM From BPMV
    G02502468Courtesy of GENERAL MOTORS CORP.
  5. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
About FixVault