FixVault
Home › Chevrolet › 2000 › Corvette 2D Convertible, Standard › Repair and Diagnosis › External Pages › Different car › Section 78 (Anti-Lock Brake System) › Repair Instructions › Traction Control Switch Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn off the ignition switch.
  2. Open the center console door.
  3. Pull up on the rear of the switch assembly in order to release the mounting clips; if the switch does not release from the trim plate, perform the following steps:
    1. 3.1.  Carefully insert a screwdriver into the access hole located on the rear of the switch assembly.
    2. 3.2.  Gently pull up on the switch.
  4. Disconnect the harness connector (1).
  5. Remove the switch assembly (2).
    Fig 1: Disconnecting Traction Control Switch Wiring Harness Connector
    G01728637Courtesy of GENERAL MOTORS CORP.
About FixVault