Using Old Switch
WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
- Loosely, install the Park/Neutral position switch screws to the transmission control. See Figure .
- Ensure that the vehicle will only start in the Park or the Neutral position. Readjust the switch, if the vehicle will start in any other position.
- Insert a 0.094" (2.34 mm) gage pin into the service adjustment hole. See Figure . Slide the switch until the gage pin drops to 0.59" (15 mm) depth.
- Tighten the Park/Neutral position switch bolts to specification. See TORQUE SPECIFICATIONS . Remove the gage pin and verify proper operation of the switch.