Instrument Panel Check

Turn ignition switch to ON position. Engage and disengage parking brake. BRAKE indicator should go on when parking brake is engaged, and go out when disengaged.
Remove master cylinder reservoir cap. Hold float down (brake fluid level switch is closed). BRAKE indicator should light when float is held down.
Place manual selector lever in Park or Neutral (A/T) or depress clutch pedal (M/T). Turn ignition switch to START position. Starter should crank and BRAKE indicator should go on, and then go out.
Turn ignition switch to ON position. Engine Coolant Temperature gauge should indicate current engine coolant temperature. Outside ambient temperature gauge (if equipped) should indicate outside air temperature in degrees Fahrenheit. Fuel gauge should indicate approximate fuel level. Oil pressure indicator should go on.
Start engine. Oil pressure indicator should go out. Tachometer (if equipped) should indicate engine RPM.
Run engine until normal operating temperature is attained. ECT gauge should indicate current engine coolant temperature.
Open and close driver's door. Door ajar indicator should go on when door is opened and go out when door is closed.
Road test vehicle and ensure speedometer is operating properly.
After performing appropriate testing procedure(s) and making repairs, recheck to ensure system is operational.