FixVault
Home › Chevrolet › 2000 › Tracker 4D Utility, RWD, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission Servicing › Removal & Installation › Shift Cable › Removal

Shift Cable: Removal

  1. Disconnect the negative battery cable. Put the manual selector in the NEUTRAL position. Remove the 4 screws (1, 6, 3, 4) and the 2 plastic retaining clips (2, 5) from the console. See Figure . Remove the console.
  2. Remove the shift lock solenoid connector (3) from under the carpet. Remove the shift indicator lamp. See Figure .
  3. Remove the 4 bolts from the manual selector from the floor. Raise and support the vehicle.
  4. Remove the following items from the selector lever: The retaining clip, washer and the shift select cable. Remove the select cable lock nut (1). See Figure . Remove the shift select cable from the manual shift lever (4). Remove the shift select cable (4) from the vehicle. See Figure .
  5. Inspect the shift select cable for fraying or kinks. Lower the vehicle. Replace the cable as necessary. Remove the 2 knob screws. Remove the knob. Remove the select indicator assembly. Remove the select lever assembly. See Figure .
About FixVault