FixVault
Home › Chevrolet › 2001 › C3500 HD 6.5 F, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls - 6.5L (L65) (Introduction) › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: CKP Sensor
    GM72321Courtesy of GENERAL MOTORS CORP.
  1. Lube the new O-ring with engine oil.
    2. IMPORTANT: A new TDC Offset must be learned after replacing a crankshaft position sensor. Refer to Fuel Injection Pump TDC Offset Adjustment .
  2. Install the sensor in the engine.
    3. Fig 2: CKP Sensor Mounting Bolt
    GM72320Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the sensor mounting bolt.

    Tighten:  Tighten the mounting bolt to 25 N.m (18 lb ft).

    4. Fig 3: CKP Sensor Electrical Connector
    GM72319Courtesy of GENERAL MOTORS CORP.
  4. Install the sensor electrical connector.
  5. Install the power steering pump. Refer to Power Steering Pump Replacement (6.6L Diesel) or Power Steering Pump Replacement (8.1L) in Power Steering System.
  6. Install the negative battery cables.
About FixVault