Power Sliding Door REINITIALIZATION
CAUTION:
If radio is equipped with anti-theft protection, radio must be unlocked before performing reinitialization procedure.
NOTE:
Before performing PSD reinitialization, check for DTCs. See ENTERING DIAGNOSTIC MODES under SELF-DIAGNOSTIC SYSTEM. Rear side door actuator control modules monitor position of power sliding doors at all times. Whenever battery voltage supply to a rear side door actuator control module has been removed or on-board diagnostics have been activated, power sliding door system(s) must be reinitialized.
- Turn on-off switch for Power Sliding Door (PSD) system to be reinitialized to OFF position.
- Manually open power sliding door completely.
- Manually close and latch power sliding door.
- Turn power sliding door on-off switch to ON position.
- Open power sliding door completely using "B" pillar or overhead console OPEN/CLOSE switch.
- Close power sliding door completely using "B" pillar or overhead console OPEN/CLOSE switch.