Installation Procedure

Important:  Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

1. Install EBCM (2) onto BPMV (5).

   Important:  Do not reuse the old mounting bolts. Always install new bolts with the new BPMV.

2. Install the 4 EBCM bolts (1). Tighten the 4 bolts to 5 N.m (39 lb in) in an X-pattern.
3. Connect the 2-way ABS pump motor connector to the EBCM.
4. Install the BPMV (5) to the BPMV mounting bracket (3) with the 2 bolts (4).
5. Slide the EHCU (1) back onto the frame bracket (2).

   Important:  The brake pipes are held in the proper place by a frame mounted plastic bracket. Make sure that the brake pipes stay in the correct place for proper reassembly.

6. Install the 5 brake pipes to the EHCU (1). Tighten the brake pipe fittings to 30 N.m (22 lb ft). I
7. Connect the 2 electrical harness connectors to the EBCM (1).
8. Secure the module (1) to the frame bracket (3) and fuel pipe shield (2) with the 2 nuts (4).
9. Bleed the brake system. Refer to ABS Automated Bleed Procedure .
10. Return to Diagnostic System Check - ABS .