FixVault
Home › Chevrolet › 2002 › Venture Plus › Repair and Diagnosis › External Pages › Different car › Section 1363 (Antilock Brake System) › Repair Instructions › Traction Control Switch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connectors.
  2. Push in on the switch bank in order to install the switch bank.
    Fig 1: Connecting Electrical Connectors
    G01483743Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the bolts/screws to the switch bank to instrument panel.

    Tighten 

    Tighten the bolts/screws to 2.5 N.m (22 lb in).

    Fig 2: Installing Bolts/Screws To Switch Bank To Instrument Panel
    G01483744Courtesy of GENERAL MOTORS CORP.
  4. Install the instrument panel accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY  in Instrument Panel, Gages and Console.
    Fig 3: Installing Instrument Panel Accessory Trim Plate
    G01483745Courtesy of GENERAL MOTORS CORP.
About FixVault