10 Minute Learn Procedure
WARNING: This page is about a different car, the 2002 Cadillac Eldorado. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- Tech 2
- Techline terminal with current SPS (Service Programming System) software.
- Connect the Tech 2 to the vehicle.
- Select "Request Information" under "Service Programming".
- Disconnect the Tech 2 form the vehicle and connect it to a Techline terminal.
- On the Techline terminal. Select "Theft Module Re-Learn" under "Service Programming".
- Disconnect the Tech 2 from the Techline terminal and the connect it to the vehicle.
- Turn On ignition, with the engine OFF.
- Select "VTD Re - Learn" under "Service Programming".
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. The vehicle is now ready to relearn the password on the next ignition switch transition from the OFF to CRANK.
- Turn OFF the ignition, and wait 5 seconds.
- Start the engine. The vehicle has now learned the password.
- With the Tech 2 scan tool, clear any DTCs.