Front Toe Adjustment
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the power steering gear seal small clamps.
- Verify that the steering wheel is centered and the wheels are in the straight ahead position.
- Loosen the left and right tie rod jam nuts (2).
Important: Verify that the number of threads showing on both inner tie rod ends are approximately equal.
- Rotate the inner tie rods in order to obtain the proper toe angle of 0 degrees.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Tighten the tie rod end jam nuts.
Tighten
Tighten the left and right tie rod jam nuts (2) to 68 N.m (50 lb ft).
Important: Verify that the power steering gear seal is not twisted.
- Install the power steering gear seal small clamps.