FixVault
Home › Chevrolet › 2003 › Impala LS › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Side Impact Module Replacement - Front › Installation Procedure

Installation Procedure

    Fig 1: Inflatable Restraint Side Impact Module & Components - Front
    GM307452Courtesy of GENERAL MOTORS CORP.
  1. Install the module (1) to the seat while guiding the pigtail harness through the trim cup.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the driver side air bag fasteners (2).

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  3. Gently pull the wiring harness (4) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
  4. Install the harness retaining clips to the seat frame.
  5. Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
About FixVault