FixVault
Home › Chevrolet › 2003 › Impala Police › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Entertainment System › Repair Instructions › Receiver Replacement - Digital Radio › Installation Procedure

Installation Procedure

    Fig 1: Digital Radio Receiver
    GM859167Courtesy of GENERAL MOTORS CORP.
  1. Install the digital radio receiver to the receiver bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the digital radio receiver nuts.

    Tighten:  Tighten the digital radio receiver nuts to 5 N.m (44 lb in).

  3. Connect the electrical connector.
  4. Engage the electrical connector CPA.
  5. Connect the antenna connector.
  6. Align the receiver and bracket assembly to the studs.
  7. Install the receiver bracket nuts.

    Tighten:  Tighten the receiver bracket nuts to 4 N.m (35 lb in).

  8. Install the harness retainers to the bracket, if necessary.
  9. Install the right rear compartment trim panel.
  10. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
About FixVault