FixVault
Home › Chevrolet › 2003 › SSR Base › Repair and Diagnosis › Electrical › Charging Systems › Battery › Repair Instructions › Battery Positive Cable Replacement (Battery To Junction Block) › Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Identifying Rear Battery Cover & Bolts
    GM1231396Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear battery cover bolts (1) and cover (2).
  3. Disconnect the negative and positive battery cables. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  4. Remove the positive battery cable from wire loom on top of right side frame rail.
  5. Lower the vehicle.
  6. Open the hood.
  7. Remove the nut retaining the positive battery cable at the junction box.
  8. Remove the positive battery cable from wire looms under hood.
  9. Raise the vehicle.
    10. Fig 2: View of Positive Batter Cable
    GM1232268Courtesy of GENERAL MOTORS CORP.
  10. Remove the positive battery cable from vehicle.
About FixVault