FixVault
Home › Chevrolet › 2003 › SSR Base › Repair and Diagnosis › Engine Mechanical › Cooling System (Mechanical) › Engine Cooling System › Repair Instructions › Radiator Hose Replacement - Inlet › Installation Procedure

Installation Procedure

    NOTE: Make sure the reference marks on the hoses and the radiator are lined up. A twist on the hose would place strain on the radiator fitting which could cause the fitting to crack or break.
    IMPORTANT: Lubricate the inside diameters of the hose with clean coolant prior to installation.
  1. Install the radiator inlet hose (1).
    2. Fig 1: Identifying Radiator Inlet & Outlet Hoses
    GM1490008Courtesy of GENERAL MOTORS CORP.
  2. Connect the radiator inlet hose (1) to the engine.
  3. Engage tension on the radiator inlet hose clamp at the engine using J 38185  . See Special Tools .
  4. Connect the radiator inlet hose (1) to the radiator.
  5. Engage tension on the radiator inlet hose clamp at the radiator usingJ 38185  . See Special Tools .
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
  7. Fill the cooling system. Refer to Draining and Filling Cooling System .
About FixVault