FixVault
Home › Chevrolet › 2003 › SSR Base › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Front End Sensor Replacement › Installation Procedure

Installation Procedure

  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Connect the electrical connection to the front sensor.
    3. Fig 1: Identifying Electrical Connection Position Assurance
    GM1343525Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connection position assurance (1).
    4. Fig 2: Identifying Front Discriminating Sensors Retainers
    GM1343527Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the two bolts (1) retaining the front sensor.

    Tighten:  Tighten the bolts to 8.0 N.m (71 lb in).

  5. Carefully remove the wedge that was holding the air conditioning condenser and the radiator.
  6. Install the radiator support and air cleaner assembly. Refer to Radiator Support Replacement and Air Cleaner Assembly Replacement .
  7. Install the engine splash shield. Refer to Splash Shield Replacement - Engine .
  8. Close the hood.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
About FixVault