FixVault
Home › Chevrolet › 2003 › SSR LS › Repair and Diagnosis › Engine Mechanical › Engine Exhaust System › Repair Instructions › Adjustable Exhaust Hanger Replacement - Right › Installation Procedure

Installation Procedure

    Fig 1: View of Insulator Bracket
    GM1231225Courtesy of GENERAL MOTORS CORP.
  1. Install the insulator bracket.
    2. Fig 2: View of Insulator Bracket Studs
    GM1275977Courtesy of GENERAL MOTORS CORP.
  2. Install the studs to the insulator bracket.
    3. Fig 3: Exhaust Insulator & Tail Pipe Hanger
    GM1231111Courtesy of GENERAL MOTORS CORP.
  3. Slide the exhaust insulator on the exhaust tail pipe hanger.
  4. Raise the jack that supports the tail pipe.
    5. Fig 4: View of Right Side Exhaust Insulator Nuts
    GM1275976Courtesy of GENERAL MOTORS CORP.
  5. Install the nuts to retain the right side exhaust insulator.
  6. Remove the jack that supports the tail pipe.
    7. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. Align the tail pipes to fascia as necessary and then tighten the nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  8. Lower the vehicle.
About FixVault